Good catch. My z axis belt was a little off the pulley. Now I feel Sheepish
Best posts made by datasmasher
-
RE: Z motor on delta printer moving faster the other motors
Latest posts made by datasmasher
-
RE: G30 S-1 not reporting an offest
I cleared my browser's cache and that seems to have fixed it.
-
RE: G30 S-1 not reporting an offest
I get toast notifications saying the commands ran ok, but that is all.
-
RE: G30 S-1 not reporting an offest
No console response from M115, but here are the details from the Machine-specific tab:
Board: Duet WiFi 1.02 or later
Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 2.05.1 (2020-02-09b1)
Duet WiFi Server Version: 1.22 -
G30 S-1 not reporting an offest
Has anyone encountered a scenario where the G30 S-1 command does not return an offset? I am trying to setup a BLtouch on my printer and the command shows that it completed, but I don't see the response in the console window. Thoughts?
-
RE: Z motor on delta printer moving faster the other motors
Good catch. My z axis belt was a little off the pulley. Now I feel Sheepish
-
Z motor on delta printer moving faster the other motors
Has anyone encountered a situation where one of the motors on a delta printer is moving more steps than the others? The motors are all the same and use to work fine, but now I have one moving more steps than the others. Thoughts?