Hm, how should I wire them?? Pretty sure I wired it right, but if you could send a picture/graph on which side everything goes on, that would be great. Thanks!
Latest posts made by 3d1Up
-
RE: Endstops
-
RE: Endstops
@bearer Alright, confirmed, my endstops don't work on the duet. They worked on my old board though, which is some random trash board from Tronxy. I have hit the endstops multiple times. Should I buy new endstops, if so, where? I really don't want to buy it from a chinese brand too due to shipping. Thanks!
-
RE: Endstops
@lb Hm,is it possible for you to post a picture of where that light is? Thanks.
-
Endstops
So basically when I try to home one of my x or y axis, it just jams into the end stop and makes the jamming noise. Here is the code for my homing. Thanks!
; homeall.g
; called to home all axes
;
; generated by RepRapFirmware Configuration Tool v2 on Tue May 21 2019 09:28:00 GMT-0400 (Eastern Daylight Time)
G91 ; relative positioning
G1 Z5 F6000 S2 ; lift Z relative to current position
G1 S1 X-235 Y-215 F1800 ; move quickly to X and Y axis endstops and stop there (first pass)
G1 X5 Y5 F6000 ; go back a few mm
G1 S1 X-235 Y-215 F360 ; move slowly to X and Y axis endstops once more (second pass)
G90 ; absolute positioning
G1 X15 Y15 F6000 ; go to first bed probe point and home Z
G30 ; home Z by probing the bed; Uncomment the following lines to lift Z after probing
;G91 ; relative positioning
;G1 S2 Z5 F100 ; lift Z relative to current position
;G90 ; absolute positioning; homey.g
; called to home the Y axis
;
; generated by RepRapFirmware Configuration Tool v2 on Tue May 21 2019 09:30:21 GMT-0400 (Eastern Daylight Time)
G91 ; relative positioning
G1 Z5 F6000 S2 ; lift Z relative to current position
G1 S1 Y-215 F1800 ; move quickly to Y axis endstop and stop there (first pass)
G1 Y5 F6000 ; go back a few mm
G1 S1 Y-215 F360 ; move slowly to Y axis endstop once more (second pass)
G1 Z-5 F6000 S2 ; lower Z again
G90 ; absolute positioning; homex.g
; called to home the X axis
;
; generated by RepRapFirmware Configuration Tool v2 on Tue May 21 2019 09:30:42 GMT-0400 (Eastern Daylight Time)
G91 ; relative positioning
G1 Z5 F6000 S2 ; lift Z relative to current position
G1 S1 X-235 F1800 ; move quickly to X axis endstop and stop there (first pass)
G1 X5 F6000 ; go back a few mm
G1 S1 X-235 F360 ; move slowly to X axis endstop once more (second pass)
G1 Z-5 F6000 S2 ; lower Z again
G90 ; absolute positioningThanks!