I cannot seem to get the autocalibrate to work as documented on my newly upgraded Rostock Max V2.
Here is the issue.
Using FSR with the John SL board.
I have removed the endstop screws on the shuttles as the endstop offsets are calculated in the auto bed compensation.
Homed height the manual way gives me a total height of 363.8mm. Works well at this setting and prints very nice.
I set the bed to 80 and the hotend to 220 (I print a lot of abs)
I commented out the 5mm offset in the homedelta.g file.
M558 P5 H3 F130 T6000 I1 ; Set Z probe type to switch and the dive height + speeds
G31 P1000 X0 Y0 Z0 ; Set Z probe trigger value, offset and trigger height
M557 R100 S20 ; Define mesh grid
I reboot the Duet3 Ethernet (Firmware 2.03)
Home the axis
Run the Autoconfigure and get a homed height of 366.328mm an offset of approx 2.5mm
Calibrated 7 factors using 13 points, deviation before 0.262 after 0.038
My FSR setup is very sensitive and I know my bed is not deflecting 2.5mm
G30 S-1 shows an offset of -0.44
If I edit my config.g file
G31 P1000 X0 Y0 Z-2.5
rerun the process I get a homed height of 363.859
(right where it should be)
I have deleted the retract and deploy files, so these files are not in play.
when i run the mesh bed compensation I get a large offset.
G29
Warning: the height map has a substantial Z offset. Suggest use Z-probe to establish Z=0 datum, then re-probe the mesh.
69 points probed, min error 2.140, max error 2.507, mean 2.372, deviation 0.088
Height map saved to file heightmap.csv
which refers to the large offset in the g31 command.
Does anyone have any thoughts on why the homed height is not working properly?
Thanks in advance.