OKI will try it tomorrow. thank you so much.
Latest posts made by lacs2711
-
RE: Endstop error
sorry
M115
22.10.39M115
FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 2.0(RTOS) ELECTRONICS: Duet WiFi 1.02 or later FIRMWARE_DATE: 2018-06-05b3 -
RE: Endstop error
when I try to home X it says
22.06.50G28 X
Error: G0/G1: insufficient axes homed -
RE: Endstop error
I'm pretty sure they are not swapped, here M119 along with a picture
21.51.57M119
Endstops - X: at min stop, Y: not stopped, Z: not stopped, Z probe: not stopped -
RE: Endstop error
; homex.g
; called to home the X axis
;
; generated by RepRapFirmware Configuration Tool v2.1.2 on Thu Nov 07 2019 17:27:04 GMT+0100 (Centraleuropæisk normaltid)
G91 ; relative positioning
G1 H2 Z5 F3000 ; lift Z relative to current position
G1 S1 X-255 F1500 ; move quickly to X axis endstop and stop there (first pass)
G1 H2 X5 F3000 ; go back a few mm
G1 H1 X-255 F120 ; move slowly to X axis endstop once more (second pass)
G1 H2 Z-5 F3000 ; lower Z again
G90 ; absolute positioning -
RE: Endstop error
; homeall.g
; called to home all axes
;
; generated by RepRapFirmware Configuration Tool v2.1.2 on Thu Nov 07 2019 17:27:04 GMT+0100 (Centraleuropæisk normaltid)
G91 ; relative positioning
G1 H2 Z4 F3000 ; lift Z relative to current position
G1 H1 X-240 Y-240 F1500 ; move quickly to X and Y axis endstops and stop there (first pass)
G1 H2 X5 Y5 F3000 ; go back a few mm
G1 H1 X-240 Y-240 F120 ; move slowly to X and Y axis endstops once more (second pass)
G90 ; absolute positioning
G1 H2 X-26 Y6 F3000 ; go to first bed probe point and home Z
G30 ; home Z by probing the bed; Uncomment the following lines to lift Z after probing
;G91 ; relative positioning
;G1 S1 Z4 F50 ; lift Z relative to current position
;G90 ; absolute positioning -
RE: Endstop error
here's what it writes when I send M119
the first is triggered, the second is not triggered:1: 21.28.07M119
Endstops - X: at min stop, Y: at min stop, Z: not stopped, Z probe: not stopped2: 21.28.22M119
Endstops - X: not stopped, Y: not stopped, Z: not stopped, Z probe: not stoppedDid not now that it was not a duet I had bought, but can see that it says on the back that it is a copy.
sorry if i have wrongly asked for help. -
RE: Endstop error
OK I have measured on endstop with multimeter 20k, they go from 0.00 to -8.30 when activated.
hope it makes sense -
RE: Endstop error
I have tested endstop in machine probeties, and they go from no to yes when i enable them.