Hi all,
first of all id like to say that I am new to this forum and have tried to search a little bit for the answer to my query to no avail.
I have several related questions to connecting the duet 2 wifi to a CR-10 and I cant seem to find a how-to or guide.
any here are my queries.
-
do the original connectors for the cr-10 stepper motors fit the duet board, if not is there a pin out diagram that anyone has that can assist me to rewire a new connector, bearing in mind the wiring from the original stepper is all black.
-
the duet board calls for a 3 pin connector for the axis end stop switches but the cr-10 is only 2 wire, again can anyone provide guidance on this.
-
I am going to use the PSU that came with the CR-10, I assume the small control board that is mounted to the back of the case is no longer required for the bed heater and I can wire the bed directly from the board.
thanks.