Not a clone and i have rewired several times. I am very ocd when it comes to wiring. i have also change it out with another brand new sensor with same intermittent results.
Latest posts made by 1SLOWc6
-
RE: Strange issues with CORExy, sensorless homing, BLtouch.
-
RE: Strange issues with CORExy, sensorless homing, BLtouch.
Sorry I edited my last post. I typed that while having a conversation with someone here at work. Just to be clear the probe works and is calibrated but randomly malfunctions and the bed never stops driving up until you shut the printer off.
-
RE: Strange issues with CORExy, sensorless homing, BLtouch.
I will give those a try. Sensorless homing is working but for some reason the probe randomly doesn't deploy and the bed drives through the hotend. Something is causing it to randomly do this. It will work a couple times then surprise you out of nowhere the probe doesn't deploy and it will keep driving up.
On the micro stepping I was told to do that for the sensoreless homing needing more accuracy. Is that not the case?
-
RE: Strange issues with CORExy, sensorless homing, BLtouch.
I/m in houston. do they work now?
-
Strange issues with CORExy, sensorless homing, BLtouch.
just to give you a idea this was/is my first printer and I bit off more than I could chew= hind site 20/20! the printer is a folgertech FT-6 once again hind site 20/20.... I never built the printer stock, it had the duet board, mosquito hotend, and 713 maker carriage installed from the first print and actually did well(2 calibration cubes). I already had Tk wards CORExy conversion, and a bltouch on hand and decided to install it. had to make some modifications but got it all together. I'm very good with fabrication so building things has never been a issue for me. Though I lack the experience/knowledge in the programing/code department for sure.
After getting it all back together I had no way to mount the end-stops so i decided to go sensor-less.
it kinda works sometimes but it randomly drives the bed into the hotend when homing (not everytime) and I have to shut it down. It wasn't hard to get a first layer without the bltouch but i cant for the life of me consistently get a good first layer with it. Now another weird issue popped up the other day for some reason when I turn the machine on the hotend says active and setpoint/standby is set to -2xx degrees for some reason. I'm at the point i would be willing to pay for someones time to sit down and help my get this thing ironed out.... I have considered scrapping this thing because I have at least 200 hours of trying to figure out the darn configuration and still having issues. please take a look at it tell me if you see anything i should change. also im using cura so if you have a start and stop code it would be appreciated.
bed.g
cancel.g
config.g
tpre0.g
tpost0.g
tfree0.g
stop.g
start.g
sleep.g
retractprobe.g
resurrect.g
resume.g
pause.g
homez.g
homey.g
homex.g
homedelta.g
homeall.g
end.g
deployprobe.g
config-override.g