i tried to change P5 to P1 and change the p paramater in g31 but it doesnt seem to work so i wil try to use a relay hopfully it wil work this way.
Thanks
Latest posts made by willyemiel
-
RE: PNP Sensor not working
-
RE: PNP Sensor not working
@bearer i am using 12V power supply and
The sensor is rated for 12V -
RE: PNP Sensor not working
the PNP sensor is a NO.
the voltage when triggered is 3.0V end when not triggered 0.1V the max voltage that was on the in pin is 3.6V
i connected the the signal wire with 3V to the IN pin on the Z-Probe heather
i am using a 30K and 10k resistor.
i have checked continuity and it is good
the pcb version is 1.04could the duet be damaged from that 3.6V?
i wil try to change the M558 value thommorow.
Thanks -
PNP Sensor not working
i followed the guide sugesting how to connect the pnp sensor using the resistor but in the web gui is keeps telling me that is is already on and reads value 1000.
if i mesuere the voltige it is over 3v when trigerred and onder 1V when not triggered .
the PNP sensor is powered using a always on fan connector
i tried multiple configs and settings in the config an homing filles but couldn't figure out why is wasen't working
please help! thanks in advance
homez.g homeall.g config.g