Hi, @oliof ,
That corner is more shiny than the others. It might be a problem there...
However, now, after soldering the capacitors, I see that in the Z corner, the C101 capacitor(I think) is missing.
I need to find the resistor and solder again.
Hi, @oliof ,
That corner is more shiny than the others. It might be a problem there...
However, now, after soldering the capacitors, I see that in the Z corner, the C101 capacitor(I think) is missing.
I need to find the resistor and solder again.
@alankilian , thank you for help. Is very valuable and apreciated.
The board was never used, so I'm noob.
I never power the board with other than 24v. I also checked the polarity before powering the board.
The D1 looks good. I have some resistence on one side and almost zero on the otherside.
Tomorrow I'm going to buy some parts to replace the old capacitors.
@alankilian, no ofence. I've read the page from you and applyed the steps from there. I've read other pages also. However, none of them descibed the behavior from my side. I look closer an saw there were 4 inflated capaciters. I need to solder new capacitors and try again.
@alankilian , I've erased and then removed the jumper to flash. The flash was successful, but after that I expected to see a com port. Instead, the diag led is on and anoter one on the left side of the usb port.
I've typed wrong... no console after reset...
The 24v power supply is not connected.
@dc42 , here is my board.
I've erased and up loaded latest combined firmware but now the board doesn't do anything at all. Now console after reset.
@alankilian , I'm not on any those situations. However, It might be a solution to erase the board and see how that goes...
I have an old 3d printer project to finish. After I bought the board(duet 2 maesto) I never tested. Now I'm trying to setup all the machine, but the device seems to reset continuously.
What should I do ?
I need an increased power with 50w, I think. I'll consider buying a 14.6A power supply.