Thank you for the detailed answers.
I read a lot in this forum and in the wiki and I convinced myself to replace the original thermocouple with a 3mm cartridge PT1000. I need to modify a little bit the hardware of the extruder but it's doable and I think that it'll be a nice improvement over the old thermocouple + AD597 amplifier.
Thank you all again!
Latest posts made by maxvi8
-
RE: AD957 thermocouple compatibility
-
AD957 thermocouple compatibility
Hi all,
I recently bought a Duet 2 Wifi board in order to replace the original board that came with my delta printer. The extruder uses a type k thermocouple with an AD957 amplifier. Is it possible to wire it directly to the Duet 2 Wifi? If so, what are the configurations you are suggesting?
Thank you