@t3p3tony So I noticed that with the pcb mounts for the mag balls when i was close to the tower it was too close for the rod ends and they were lifting away from the mag balls. I was able to replace the carriages with ones that put the magballs at a downward angle and now my G32 returns a deviation of .015 all the way to the edge of the bed. I am still working on getting a good height map since so much changed with the carriages.
Best posts made by sudodelta
-
RE: Height Map issues
Latest posts made by sudodelta
-
RE: Height Map issues
@t3p3tony So I noticed that with the pcb mounts for the mag balls when i was close to the tower it was too close for the rod ends and they were lifting away from the mag balls. I was able to replace the carriages with ones that put the magballs at a downward angle and now my G32 returns a deviation of .015 all the way to the edge of the bed. I am still working on getting a good height map since so much changed with the carriages.
-
RE: Height Map issues
@t3p3tony If I reduce my Delta calibration radius from 110 to 95 I will get a deviation of .03 but my height map will still show those highpoints that it doesn't seem to be able to compensate for when printing.
-
RE: Height Map issues
@t3p3tony Apologies for the delay, had a baby last week
I can't find any play in anything and no clips are being contacted. If I bring in the outer probe points the deviation does improve though. -
RE: Height Map issues
@t3p3tony The deviation on the G32 never gets below .130 (after running it 8 times) and the height map issue persists. I am beginning to think my endstops are to far out of sync, M666 X-4.079 Y0.542 Z3.536 A0.00 B0.00, i thought the g32 would have compensated for it but maybe it's too severe.
-
Height Map issues
I have been struggling with the above height map ever since installing a smart effector. I even took apart my whole frame and reassembled it, only to have the exact same issue. The high points are near the pillars and the low points are in-between the pillars. I am using the PCB magball mounts on the carriages.
I have check the calibration of my frame and confirmed nothing is loose anywhere. I am currently on firmware 3.3.
Below are some pictures of my printer as well as config files. Any help would be appreciated.