Swapping the order of those two lines fixed it! Odd that it worked before, but it is now behaving as expected. Thanks!

My BLTouch was calibrated and working well. I had to replace the nozzle, so I disassembled/reassembled my hotend and needed to re-calibrate the z-height. I followed the recommended procedure of:
Move nozzle to bed using paper as test
G92 Z0
Move nozzle to 5mm
G30 S-1
Repeat - results (0.145) were consistent +/- 0.005 mm.
Set trigger height in config.g like this:
G31 P25 X28.5 Y-5 Z0.145

Everything else was unchanged.

What is strange is that the nozzle moves to 5.70mm after homing, instead of the 5.145mm as expected. And if I test after homing by moving the nozzle to G1 Z0, it presses into the bed. Backing it off to 0.55mm passes the paper test as originally measured. So it seems there's a 0.55mm difference applied to the trigger height. How can I trouble-shoot?

Thank you!

homez.g
homey.g
homex.g
homeall.g
config.g