The results are as follow:
16-11-2020 17:24:27 M584
Driver assignments: X0 Y1:3 Z2 E3:4, 3 axes visible
16-11-2020 17:24:55 M906
Motor current (mA) - X:1450, Y:1450, Z:1450, E:1200:1200, idle factor 30%
16-11-2020 17:25:15 M913
Motor current % of normal - X:100, Y:100, Z:100, E:100:100
16-11-2020 17:25:34 M569 P2
Drive 2 runs forwards, active low enable, step timing fast, mode spreadCycle, ccr 0x101b4, toff 4, tblank 2, hstart/hend/hdec 3/3/0, pos 0
16-11-2020 17:26:01 M350
Microstepping - X:16(on), Y:16(on), Z:16(on), E:16(on):16(on)
16-11-2020 17:26:20 M906 Z1000 G91 G1 H2 Z100
Everything looks ok in the console, however the motor doesn't rotate (also no vibration). The shaft of the motor can be rotated without any resistance, so there is no current.