Interesting, then I think I may have had an issue from day one.
Anyway I will reconfigure and test that and get back to all the great help thus far.
Interesting, then I think I may have had an issue from day one.
Anyway I will reconfigure and test that and get back to all the great help thus far.
OK, then something went or I managed to help it, but really curious now so as not to repeat even by accident.
I reconnected the board to real power as I had remembered what lights were on when I noticed the problem initially.
This is what comes up now. Nothing connected other than power.
Open to suggestions in the mean time, waiting on new cables and sd cards which should be available for pickup in a day or two.
@droftarts Mine seems to have a 'c' at the end so it should be functional button. just not doing anything.
@droftarts it was right when I tested it, not connected now, just USB.
!
Tried on 2 computers, several USB ports, a powered USB hub connected via Thunderbolt, nothing gets those red lights to go off and nothing appearing under tty as it did the initial setup attempt.
So does the jumper reset switch approach vary on this board?
Thanks, seems that may be.
"On older boards do this by holding down the Erase button for at least 1 second, then press the Reset button. On newer boards there is no Erase button; so fit a jumper across the Erase pins, then connect to USB for a few seconds, then disconnect from USB, remove the jumper and connect to USB again. You may have to do this a couple of times if the Duet does not appear in the Device Manager."
To be clear, I have jumpers and RESET button, so the above quote is a little fuzzy. Tried a few variations. Still two beady red eyes starring at me.
Well I seem to have a viable SD Card, so I will look for the Erase jumpers and try that approach.
Ordered more two cables and another couple of SD cards.
So following up. Board seemed to be functional, but couldn't get the wifi information to stick. Anyway, moved onto start testing and connected a motor/arm from the delta printer. Nothing, browser window showed an error and so I unplugged. Tested wires, plugged back in. Nothing, no wifi light, well no blue/green lights, just two red. No thing connected now, still just 2 red lights. Swapped through 3 cables. Nope.
Thank you Danal, but no diag light, no connection, not even usb connection recognized by computer. No burn smell, no burnt marks that I can see. SD card removed, still 2 red lights.
I'd erase the firmware, well maybe I have now (silly little button) no idea, steps seem to be a little vague. Anyway, two red lights, nothing else.
Bummer.