T3P3Tony, It works but only with M42 command, the M280 does nothing. Anyway I'd call it enough for me. One more question about M42's "Use M42 Px Sy to set pin x to value y. The S field may be in the range 0..1 or 0..255" - the value of "S" corresponds to pulse width in microseconds or something other?
Latest posts made by guesswhoo
-
RE: Panning dual extruder setup and configuration
-
RE: Panning dual extruder setup and configuration
That's the site I'm actually stuck on, becouse I need to know which command (M42 or M280) to use to control servo via pin no. 8 (heater 3) and what "Pnnn Pin number" for M42 or "Pnnn Servo index" for M280 would be if using pin no.8
-
Panning dual extruder setup and configuration
Hello,
Recently i've found nice project which i'd like to try out on my printer https://www.thingiverse.com/thing:1362557
Its a digital servo based panning dual extruder.
Why I write here is that, I'd like to ask for some help in wiring the servo to my v1.0 Duet and setting proper G&M codes in configuration. So far i've found basic information about M280 P# S50 and M307 H# A-1 C-1 D-1.
I have tower pro mg-16R servo and I want to use HEATER3 to control it.
how should the configuration file look like to make it work?
Any help would be greatly appreciated! -
Thermistor fail situation
Hello everyone
I've recently encountered an event of one of the thermistor wire breaking. Thankfully watchdog worked perfectly- hotend cartridge was shut off. Also I've discovered a resurrect.g file and it would be really nice to get a use of it (+16hrs print at 0.04mm). Unfortunately as the hotend was shut, the bed also turned off which result in print detachment Is there possibility in firmware to leave heatbed on even if heater error occured?