I have now managed to access my wifi network using m552 s0, m587 with password info and m552 s1
Latest posts made by hartwood
-
RE: Duet preparing problems with Mac
-
RE: Duet preparing problems with Mac
I have now tried Printrun software and this connects, however if I run M552 S1 Code it comes back with this message...
m552 S1
SENDING:M552 S1
WiFi reported error: no known networks found
WiFi module is idle -
Duet preparing problems with Mac
Hi,
I have tried seaching for this but could not find a solution.
When preparing the Duet card via USB on my Mac for Wifi usage I get the following problems.
using this setup https://duet3d.dozuki.com/Guide/1.)+Getting+Connected+to+your+Duet/7Run ls /dev/tty.*
Give me a response of /dev/tty.usbmodemFA131
So I then type
screen /dev/tty.usbmodemFA131 115200
give me this response...
RepRapFirmware for Duet 2 WiFi/Ethernet Version 2.01(RTOS) dated 2018-07-26b2
Executing config.g...Error: Bad command: FOR TESTING ONLY! USE https://configurator.reprapfirmware.org/ to generate configuration files for your printer! WiFi module is disabled Warning: Heater 0 appears to be over-powered. If left on at full power, its temperature is predicted to reach 275C. Done! RepRapFirmware for Duet 2 WiFi/Ethernet
I then cant type anything else.
If I restart Terminal and try it again, sometimes i get a message saying that 'resource is busy try again' and then it gives me the 'sorry could not find a PTY' so I disconnect the Duet card and plug back in again and then I either get the same message or the first message above.
Can anyone shed any light on this?
Rob