Thank you, it is, I bought from Ooznest UK.
Latest posts made by J1mbo
-
RE: New Duet 2 Wifi 1.04 only red leds
-
RE: New Duet 2 Wifi 1.04 only red leds
Absolutely nothing. USB cable is the only thing.
-
RE: New Duet 2 Wifi 1.04 only red leds
Anything more on this? Am keen to get it working as its the only thing holding up the completion of my printer.
-
RE: New Duet 2 Wifi 1.04 only red leds
No, I wouldn’t say so. If fact I wouldn’t say any of the components get “Hot” or even warm when USB cable attached.
No COM ports found when I try to connect with YAT software either.
-
New Duet 2 Wifi 1.04 only red leds
Hi all. It seems I have an issue with my new duet 2 wifi. I am unable to get the 3.3v or wifi leds to illuminate. There are two red leds, one next to the usb in port and one next to the unlit 3.3v led.
I had connected the 24v Vin correctly before and the board was functioning fine and even had a couple of z axis motors running to test the board before install to my printer. The jumper is placed for 5v Internal. However now I only get the 2 red leds when connected to usb and cannot connect via either VAT or DuetWebControl.