Output is 23.9v
Latest posts made by Joeboofx
-
RE: Burnt my board!
Thanks for everybody's help. Just received a new board and I'm going to try again.
-
RE: Burnt my board!
Yeah, new board maybe 4ish months since I bought it from Matterhackers.
-
RE: Burnt my board!
So yeah the power wires were temporary. The power supply came out of a Delta style 3d printer and I just hadn't gotten around to switching them out. Laziness on my part. Off hand I'd say they're 18-20 gauge.
-
RE: Burnt my board!
@Joeboofx said in Burnt my board!:
"attempt to move motors when VIN is not in range"
Do you think that could have been why I got the "attempt to move motors when VIN is not in range" message / error?
-
RE: Burnt my board!
I wouldn't think so? there's only one way to plug in the Panel. I don't think I could have gotten that wrong?
-
RE: Burnt my board!
Also, I had the Panel Duex connected when it happened
-
Burnt my board!
Hi guys, this is my first post here. I just recently started setting up a 3d printer so I followed the instructions and finished the wiring. I had it connected to the wifi and was monitoring it through the control app. I tried to home x to see if it moved and it said "attempt to move motors when VIN is not in range" while I was trying to figure out what that meant a little puff of smoke came off the board and I powered it off. Now the little processor thing is burnt and it doesn't do anything with power, only the blue power led goes on. Pretty sure its dead, I just want to know what went wrong! Please help! Also, I'm using a 24v power supply with a duex5 and a panel duex.