Posts made by ladal

@jay_s_uk
Thanks much, I am very stupid

Lada

Hello,

I have two versions of smart effector "v2 and v4", I have the same problem with both.
To set the sensitivity, only the example "M672 S105:50:205" works and returns the setting "M672 S105:205:50".
The sensitivity changes and the LED flashes 5 times.
If I try to change it to a value other than "50" or "205", no change is made, nor does the LED blink. Diagnostic and reset commands work correctly.

Thanks in advance for your answer

Lada

Thanks much for reply, I wait for version RRF 3.02
Its super HW for control 3D printers.

Lada

Hello,
I build config for new corexy printer with Mainboard 6HC + Expansion 3HC + SBC on DSF 1.2.5 & RRF3.01RC5 & DWC 2.07.
I use this command for 2pcs filament sensor connected on 3HC board input io0.in & io1.in
"M591 D0 P3 C"1.io0.in" S1 R70:130 L24.8 E3.0"
"M591 D1 P3 C"1.io1.in" S1 R70:130 L24.8 E3.0"
What is correct result, for this problem, please?

Thanks for reply
Lada