TP-LINK RE200 good choice ?
Latest posts made by Leth'e
-
RE: BL-touch related question
Even I changed my wifi on the card to ESP-07S to have external antenna still having connection issues, rather than the ones that advised in duet page, do you guys have any suggestions to make the connection a bit more not 'trying to reconnect'
-
RE: BL-touch related question
That is the place I use, usually I get 2 message, first says config.g saved, second says error to save config.bak / I also only edit config.g
-
RE: BL-touch related question
Well nice one for sure,
In my condition, I just take the damn thing off, and solder it old guy habits, if it moves too much, put another screw on it
I managed to work it out, somehow my duet is not saving the config I am writing to config.bak and rest, so it was staying on air. I copied config to all, then did the mesh grid stuff. I am good, its working at last, but I am saying duet and bl touch, not a good deal.
Now I have to work out to improve the prints cuz somehow I am getting partial less extrusion in some spots, empty areas with first layer and the outer rim. anyway good luck and I can help if anyone needs help they can text me -
RE: BL-touch related question
I was able to make it work, there was a connection issue with the copper roundup on the top. The cable was ripped, I soldered and its working, Can someone direct me to somewhere where I can read about the mesh grid locations and why my X and Y endstops are not working anymore
-
RE: BL-touch related question
Does extending the cable has an effect on it ?
-
RE: BL-touch related question
Thanks for quick reply, actually I got most of it from your posts, its 3d touch, not sure but bought around 2019 for an old ender 3, now running a corexy. Even if I give from m280 p3 S90 or S120 or S110 or S160 with or without I1 from the console it does not do anything. At the begining it does 2 drop and pull thought, red and blue lights are there. I deleted from the config override the Heater 3 value as well.
-
BL-touch related question
Hello,
I am having difficulties finding the answer for why my sensor is not deploy or retract at all. I did the connections accordingly to the instructions, I bought non-original since I was not able to as it was not being shipped to country I live in. Anyway, I also tried the I1 method, P5, changing the heater to 7 checking the cables with the multimeter, the last thing I did not tried is 240ohm resistor between zmin and g. Config, deploy, retract files are as follows;
FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 2.05.1 ELECTRONICS: Duet WiFi 1.02 or later FIRMWARE_DATE: 2020-02-09b1
config.g.txt deployprobe.g.txt retractprobe.g.txt homeall.g.txt homez.g.txt bed.g.txt