@droftarts The fan was a 5V one wired to the always on fan header on the board (i bought it at the same time as the board, confirming it was a 5V fan). There are no faults in the wiring that i can see, all wired up as the guide said. The failure occurred on startup.
Latest posts made by Matt7
-
RE: Board not working(possibly broken)?
-
RE: Board not working(possibly broken)?
@droftarts My PSU voltage is 24V, fan is 5V for the extruder and the rest is passively cooled (only the one fan). I'm using an inductive Z probe at the moment.
-
RE: Board not working(possibly broken)?
@bearer I was told by E3D to repost to get an admin to comment on it, i tried the fallback procedures which didn't help.
-
Board not working(possibly broken)?
I have recently bought a duet 2 Wifi (bought on the 8th March and received on the 11th) and it stopped working 2 days in after working perfectly on the 11th. Now it won't connect to my computer over wifi or even be recognised when plugged in with a USB cable, disconnecting everything from the board produced not better result. The nozzle and heated bed immediately begin to heat up when starting and the processors becomes very hot to the touch. I bought it from E3D and i was recommended here to resolve my issue.
-
RE: Board suddenly non responsive
@bearer I can confirm its just a shadow
-
RE: Board suddenly non responsive
@droftarts it was working perfectly fine yesterday. I bought it from E3D on Sunday and received it on Tuesday.
-
Board suddenly non responsive
Hi there, i received my duet 2 wifi about a week ago and it has run perfectly so far, full movement and heating up, printing and wifi control from my computer. I booted it up this morning and wouldn't connect to my computer, i thought that was strange so i plugged it into my computer and searched for it in YAT, it wouldn't show up there either. I tried disconnecting and reconnecting everything to no avail. When i start up the board now in the printer, all LED's light up except usb power and the hotend starts to heat up as well as it stating its heating the heated bed with the indicator LED even though i don't have a heated bed installed, the processor also heats up a lot. I'm at my wits end, i also tried to reinstall the firmware but it hasn't worked as it wouldn't show up in BOSSA. Please help me.