@fcwilt ok thanks for the help now I understand. so in g31 I put the distance from the effector center to the probe then in G30 that of the extruder to the effector center
Posts made by nemecek
-
RE: offset probe
-
RE: offset probe
@dc42 please can you reply when you have 5 minutes time please? thanks in advance
-
RE: offset probe
@dc42 perhaps you told me that in my case the offset is measured from the center of the effector to the probe even if I have a distant nozzle
-
RE: offset probe
thanks I don't think I understand the first part. google translate is not perfect.
so I set the offset from the nozzle to the probe? then I leave the G10 parameters to define the difference as in the picture? -
RE: offset probe
ok thanks so here I set the difference of the extruder to the effector?
-
offset probe
good morning I don't understand something I have a problem my extruder is not centered on my effector. so for the bltouch offset what do I put? from the effector center to the bltouch? or from the extruder nozzle center to the bltouch?
-
RE: G29 G32 😱
good morning I have not yet solved the problem today I noticed that after correcting the G32 when I go home I start with the correction of the x y axes as you see in the photo
so I was wondering if I had to resume my probe offset starting from the correction? I tell you this because if I do a small survey 100 x 50 with G29 then I print a picture of 100 mm my nozzle is not precise on the survey that I marked with a pen on the plate -
RE: G29 G32 😱
good morning I did not understand correctly. did you tell me about the g10 should i enter the offset here?
-
RE: G29 G32 😱
to make you better understand when I go down the z to 0 leffector and centered on my plate. but I nozzle no
-
RE: G29 G32 😱
@Phaedrux no my titan aero is not in the center of my effector so the nozzle is not in the center of the effector
-
RE: G29 G32 😱
hello can you tell me if I have to set the offset of my extruder with respect to the center of the effector? maybe that's why the map doesn't compensate well
-
RE: G29 G32 😱
@Phaedrux
G29 S1 P "heightmap.csv also delete this from simplify3d start script? bI'm sorry if I write badly I use google translate -
RE: G29 G32 😱
G29 S1 P "heightmap.csv"
G29 S1 P "heightmap.csv" so delete this from the start?