Phaedrux, thanks for the reply! I made all the changes you've mentioned besides pressure advance as im saving that for a bit later. I have a tevo tornado with a geared extruder. My bowden tube is around 400mm. I am testing a print right now and my extruder is flying! might have to turn acceleration down on that lol
Latest posts made by nitekillerz
-
RE: Machine "pausing" between perimeters or layer changes
-
Machine "pausing" between perimeters or layer changes
Hello, i have a tevo tornado and i am using the duet 2 wifi. I used the config and only modified m566 e to 400 from 120 after seeing many post saying its due to low jerk settings. i do know know anything about jerk so i dont know if 400 is still low on a bowden system.
i am using s3d and the same exact profile from before but i have checked to use relative extrusion distances based on another similar thread. i am using 100mm/s print speed, averaging around 60.this hesitation is causing big blobs on my prints and im not sure if the jerk increase in only the e helped or if it was too small of an increase to notice
here is my gcode
https://www.dropbox.com/s/ae0kchyrwwporxk/gcocd.txt?dl=0