Thank you!
Latest posts made by papptacsi
-
RE: Chamber heater and therm. connect to Duet exp. connector pins
I would have one more question now.
I can change the Y and Z controls? And so I can connect the two Y motors with a separate connector to the board?
Am I correct? -
RE: Chamber heater and therm. connect to Duet exp. connector pins
Thank you for your reply!
That's what I was thinking, but I was not sure.
If I'm still having a question or problem with this project, I will continue this post.
-
Chamber heater and therm. connect to Duet exp. connector pins
Hello!
I would like to change the electronic system of my CubePro Duo to Duet 2 Wifi.
The list of the appliances which should be control with the board:- 1 pcs X motor
- 2 pcs (dual) Y motor
- 1 pcs Z motor
- 2 pcs Extruder motor, heater, thermistor
- PWM and always on fans
- Endstops
- Heated bed, thermisztor
- Heated Chamber with SSR, thermistor
My question is the following: Is it Duet 2 Wifi cabable and enough to control the appliances by itself or do I need the Duex expension board too?
Heated chamber is the queried issue for me.
The following link contains a description about the connection of heated chamber SSR input with the Duet expansion connector pin directly without the Duex. (for example Pin3 and Pin8)
But for me it is not obvious that the expansion connector pin could be connected directly with the heated chamber's thermistor too. (for example Pin35 and Pin36).Link (Connecting a SSR directly to the expansion connector):
https://duet3d.dozuki.com/Wiki/Connecting_and_configuring_a_chamber_heaterCould you please help me about this question?