Best posts made by Quattro500
Latest posts made by Quattro500
-
RE: Heightmap seems to be not used
Hello again,
Printer runs fine after calibration and Manual leveling of the bed. Heightmap Shows a max error of 0,1mm. works fine but still the first layer seems not to be equal thick. wide and quite thin ropes in first layer. thickness is not equal. does not really influence the print but still not understood.
Very interesting fact: height map Shows an error of -0,1 mm for a Region of the bed where the widest ropes are printed. Can there be a +/- mismatch somewhere?
BR Marc
-
RE: Heightmap seems to be not used
may not have been calculated I wanted to say
-
RE: Heightmap seems to be not used
Yes I have. But as I did not start up after G32 These changes in the overload file may been calculated. Could that be the reason.
I'll start up right now. and start again. -
RE: Heightmap seems to be not used
Hello all,
I'm back again on this Topic.I had a detailed readtrough the docoments and now it should be right.
But I still don't get a bed leveling while printing.
After G32 and M500 I started a print with a G29 S1 in front (no homing after G32) but still the same behaviour I think.
A M122 give this info:
Is this correct? Bed-leveling active? The print Shows not, but I'm no sure.Any ideas?
-
RE: Heightmap seems to be not used
I did not update but tried this:
I do not get a config-override.g or any Change in the values.
Where to pick up the Version 2.04?
-
RE: Heightmap seems to be not used
Offset is updated. but that should not cause the problem I think.
Firmware is 2.0. I'll update right now and Change to P9 for BLTouch.
Again thanks to all helping a gearhead struggling with programming.
But the auto-calibration does not Change anything in the config.g. What's wrong here?
-
RE: Heightmap seems to be not used
I use a duet WiFi, should be fine?
autocalibration was running right in the moment, no changes to be found
Hot end runs perfect
the bltouch offset should be something About 25mm in Y, correct
what is the difference between P4 and P9?
-
RE: Heightmap seems to be not used
Hi,
I have a Little Monster and use a bl-touch for probing.
The plate is glass.Here is my config.g and bed.g
Hope anybody finds the mistake.
In this Moment I checked the mechnical configuration. The heigt of the upper carriers above the bed differs by About 0,05mm.
The saved heightmap Looks like this.
quite bad but 0,39 mm over all should not be too much for compensation I think.As the print reaches the lower area of the plate, print gets loose.
Thanks for your Feedback
Marc