I have taken everything apart. Tested cartridge it is 24v. the guy I bought it from is going to switch out the psu and cartridge for 12v ones tomorrow Thanks for all your guys help.
Latest posts made by SlewFPV
-
RE: Heating Fault
-
RE: Heating Fault
@Phaedrux just dawned on me and I looked to see, this still has the original cr 10 12v heatbed but it has a 24v psu. It does have a e3d v6 hotend but How can I tell if it is the 12v or 24v?
-
RE: Heating Fault
@Phaedrux Hello, Thank you for you response. I think I have figured it out. For some reason when The heat bed turns on the voltage drops from 24 to 14.. If i just do HE1 by itself the error does not occur.. I think the psu is bad..
-
Heating Fault
Hello,
First of all I am super new to duet. I just purchased a highly modified cr10 from someone that never really finished it. duet 2 wifi
E3d V6 hotend
external mosfetsI am getting a Error: Heating fault on heater 1, temperature rising much more slowly than the expected 1.6c/sec
I have done the auto tune (m303) as suggested in wiki and saved the results, still happens.
I thought it may be the external mosfet so I bypassed that and hooked directly to the board. same results.Any ideas?
Thanks