Hi, it worked Thank you very much for the help
greetz marcus
Hi, it worked Thank you very much for the help
greetz marcus
Hi, it worked Thank you very much for the help
greetz marcus
Ok, that's certainly the simple variant or? How would it go with the m563 command please?
Hello everybody,
I use a hotend fan and a component fan on my delta. The hotend fan is on P0 and is temperature controlled. He starts at 45 °. That works perfectly too.
The component fan should be controlled by the g-code. He will not. According to the file, the fan should start from the third layer. He stays out, why?
Via the DuetLocal interface I can control both fans promlemeless manually. In the config.g I have deposited the following.
M106 P0 S0 I0 F500 H1 T45; Set fan 0 value, PWM signal inversion and frequency. Thermostatic control is on
M106 P1 S0 I0 F500 H-1; Set fan 1 value, PWM signal inversion and frequency. Thermostatic control is turned off
Greetz Marcus
Perfect, I will try it after my work and report the result here
Hello Veti,
Thank you for your feedback signal. If I understand that correctly, I'm running the AutoDeltaLeveling and Meshkomp.
Then I enter M500 to save the new M665 and M666 commands in the config-override.g file.
At the end of my config.g file, I deposit the M501 command.
So here's config-override.g so the commands in my config.g file will overwrite.
Is this correct?
Hello everybody,
i hope the translator does his job well, my english is not that good.
I have now installed a Duet2 Wifi in my Predator (Delta). On my printer, I use a level sensor (push button) which also works and after the bed sample is removed.
I first determined Z Zero. Then mount the sensor and run 1 pont probe. The measure 16.255 I have then deposited in the config.g under Z sample. Then I pressed the Auto Delta Calibration. After the process was completed. Did I then run mashcomp, disassembled the sensor and run a pressure. After printing, I made the printer. Later, I started printing directly and the printer starts printing about 5 to 7 mm above the bed.
So I put the sensor back on and ran G32. Sensor off and pressure started. Finished. Printer off and printer on, printing started. Again he begins to print 5 to 7 mm above the bed.
Why? I just can not get on, can you help?
Greetings Marcus