I now have my duet installed and running after the firmware re-load. I still have to tweak a couple of settings and reconnect the power off feature, but other than that all is good.
Thank you all for all of your help and suggestions.
Best posts made by snake2155
-
RE: Help Unable To Connect in Any Way
Latest posts made by snake2155
-
RE: Help Unable To Connect in Any Way
I now have my duet installed and running after the firmware re-load. I still have to tweak a couple of settings and reconnect the power off feature, but other than that all is good.
Thank you all for all of your help and suggestions. -
RE: Help Unable To Connect in Any Way
I erased and reloaded the firmware to v2.03 using Bossa. The weird part is that it would not show up until after the erase. After loading firmware I was able to connect via wireless and did not have to reconfigure. Tomorrow I will reinstall the board and check function and if all is well I will change status as solved.
Could someone explain to me why tthe firmware needed to be reloaded and why I did not have to reconfigure my wifi settings.
Thanks.
-
RE: Help Unable To Connect in Any Way
Hello
All connections are currently disconnected from my Duet, so no chance of that.
Thanks -
Help Unable To Connect in Any Way
Hello
I have a Duet Wifi v1.04b that I purchased 5 months ago in preperation to a new printer build. I am using this along with a PanelDue 5. One week ago I connected to it via the usb port and configured the wifi with no issues and everything worked great. On calibration print #4 I noticed the paneldue read 0 degrees celcius for both the hot end and bed. I was not overly concerned with this as I was controlling the printer via wifi. On print # 5 the printer shut down in mid print. I had lost my 3.3v output between pin3 and ps on that controls my mains SSR. I then wired my power supply directly to the Duet and powered thing up. I am unable to connect via wifi, control actions via PanelDue, or connect by USB.
I then removed all connections and attempted to connect by USB with no luck using YAT, and device manager does not see the Duet ( as duet, bossa or unknown device ). Currently I have the following leds 5v - red, 3.3v - green, usb - red, and diag - red.
I purchased this unit from Filastruder and was informed that I need an Administrators approval for a warranty return. I am hoping that I am overlooking some corrective action, but I tried everything in the troubleshooting guide except erasing the firmware. I do not feel comfortable doing that without an Administrators instruction to do so.Any ideas?