Firmware Electronics: Duet WiFi 1.02 or later
Firmware Version: 2.0(RTOS) (2018-06-05b3)
Latest posts made by solidtwerks
-
RE: New to Duet. Need help with sensorless homing.
-
New to Duet. Need help with sensorless homing.
I believe I've successfully configured the X axis. I've copied the X axis g-code to the Y axis but I'm not getting the same result. The Y axis hits the limit and then continues and skips.
My printer is a CoreXY. Hypercube for those familiar.
Here is my homey.g config:
; homey.g
; called to home the Y axis
;
M400 ; make sure everything has stopped before we make changes
G1 Y-30 F8000 S2 ; move from Y0
;G1 Z1 F6000 ; Lift Z
M574 Y1 X1 S3 ; set endstops to use motor stall
M574 Y2 S3 ; set endstops to use motor stall
M913 Y50 X50 ; drop motor currents to 50%
M915 Y S3 R0 ; set sensitivity to +3 unfiltered
G91 ; use relative positioning
G1 Y-205 F3000 S1 ; move Y all the way left and stop at end
M913 X100 Y100 ; motor currents back to normal
G92 Y0 ; set Y0 at edge of glassPlease forgive me if this is not sufficient information. I am new to duet and this forum.