I have a Duet 3/Raspberry-pi3+ combo installed on a CR-10s printer. After setup with RRF3 and testing several prints, everything was operating well and I was getting high quality prints. As I was preparing to start another print, the Y-axis began exhibiting very rough operation, and the web dashboard showed "Error: short-to-ground reported by driver(s) 1". All other axis' behaved normally. I switched the wiring so that driver 0 was controlling the Y-axis, and driver 1 was controlling the X-axis. My X-axis began acting erratic while my Y-axis was just fine, indicating good wiring and stepper motor. Is there a way to fix this issue without a warranty replacement?