Hi at all!
I connectet de ribbon to conn_SD and the 4 wire... everythings seems working fine so far!!!!
Thanks a lot!

Latest posts made by Tekkineo
-
RE: Connecting Fysetc 7" to a Duet Wifi
-
RE: Connecting Fysetc 7" to a Duet Wifi
If I am right connectin the 4pin and the ribbon cable nothing happens. There is always standing connecting.
But I´ll try -
Connecting Fysetc 7" to a Duet Wifi
Hello guys!
Actually I got a Fysetc 7" (based on PanelDue V3.0) at home. I want to connect it to the Duet Wifi.
The Duet Firmware Electronics is 1.02 or later. Firmware Version is 2.02 (RTOS); Web Interface Version is 1.22.6
In the duet description I read that a can connect it via 4wire and/or the 10wire ribboncable (max 300mm).
I can connect the Display via the 4 wire connection and it works so far (but I can´t use the sd slot; this should only bei possible with the ribboncable).
Connecting the display with the ribboncable on the right top of the display is standing connecting, but nothing happens. What am I doing wrong that I can´t establish a connection with the ribbon cable... The SD-Card support would be a nice feature... -
RE: Problems with the PWM Module P0
Ok Perfect!!!
Thank you very much!!! I got it! I will order the parts and take a look for a vendor in germany. If i can´t find anyone I´ll have to send it to uk -
RE: Problems with the PWM Module P0
Hello perfect! Thanks a lot! I would take a look around to find a vendor whicht could change it!
Actually in the internet i only found a mosfet called PMV40UN2R and not PMV40UN2. In the datasheets i didn´t find a difference. Can I use the PMV40UN2R?
Thank you very very much! -
RE: Problems with the PWM Module P0
good Morning dc42!
Thanks a lot for the quick support. Ok, i can´t guarentee that when the cabels broke up the don´t touch each other. Might seem this would be the reason.
Now I wanna try to find a Company near by which could realize the change of the mosfet. Which soldering equipment is needed for replacement so I can ask the companies.
At home I got an old Ersa soldering station with a 24v micro tool which have a quite small top. How is the Sparepartnumber of the mosfet or which type is it? -
RE: Problems with the PWM Module P0
Hello Thanks for responding!
What would a Repair cost? Is it possible to avoid this failrure in future by using external mosfets and the duet will control these external mosfets? -
Problems with the PWM Module P0
Hello at all!
I got serious Problems with my duet wifi recently. One Fan of my 3d printer stopped working. It is connected to the PWM Port P0. The cable was broken so i fixed it. Then the fan was working a time. Suddenly it stopped again. I turn the printer off and cecked the wires once again. There were no problems. After turning te Printer on it still doesn´t work. After turning of I change the Fans from Fan1: P0 to P2 and Fan2: P2 to P0. with the code "M106 P0 S0" and "M106 P0 S1" i checked both ports if they were working. Fan1 was working fine; Fan2 din´t do anything.
When measuring the Port P0 a measured 23.88V with the code "M106 P0 S0" and 20V with the "M106 P0 S1"
Could you help me please becaus actually I don´t know what it is...
Thanks a lot!!!
0_1535356879863_config.txt