@Phaedrux
I don't have it on yet. I was going to try that after I get everything working. I am going to try S3D today
Latest posts made by tootison
-
RE: Ender 5 Plus Endstop Help
-
RE: Ender 5 Plus Endstop Help
@Phaedrux
I was measuring the thickness but I got that sorted out. The only thing I am stuck on now is trying to get ideamaker to work. It always over extrudes way too much around the corners. With my other printers I use a mix of S3D, Cura, and ideamaker. I have only got Cura working so far. -
RE: Ender 5 Plus Endstop Help
So no matter how many times I adjust the Z offset everytime I do a print the first layer comes out to 0.26 instead of 0.2. I have calibrated my esteps and flow rate is calibrated so I think it might have to do with slicer start code
-
RE: Ender 5 Plus Endstop Help
@Phaedrux
Do I need to put the command to use abl in the start gcode? I ran mesh compensation from duetweb so does the load it automatically when prints start -
RE: Ender 5 Plus Endstop Help
Okay I just had to reverse the motor directions and everything is moves alright. Now the only thing I am having issues is with printing files. I use ideamaker and it prints fine when going in a straight line but slows down to almost a crawl and extrudes a lot of plastic then speeds up again. Also the travel speed during the print is real slow. I think i might have something to do with the Print Start gcode. Could you share what it should look like for reprap firmware. This is my first time using anything other than marlin. I attached the gcode i tried to print
-
RE: Ender 5 Plus Endstop Help
@Jacotheron
I made those changes and not my print head moves to the front left when homing -
RE: Ender 5 Plus Endstop Help
The endstops on the ender 5 plus are on the back right corner. How do I get it to use the front left as 0,0. Right now I have it mostly working as in not crashing but the 0,0 is the back left. Also I put the offset for my bltouch in but I think i might have to reverse the neg and pos direction of the 0,0 is to the back right.
-
RE: Ender 5 Plus Endstop Help
here they are. so homing works now but the individual homing are reversed.
config.g homeall.g homex.g homey.g homez.g -
RE: Ender 5 Plus Endstop Help
@Jacotheron
I had them wired wrong but now when ever my printer homes it hits the endstops then touches them again then slams into the x and y endstops. Could you share your set up so I can see what I had done wrong? -
Ender 5 Plus Endstop Help
I just completed my ender 5 plus upgrade to duet 2 wifi. I have everything working except the x and y endstops. It seems that the duet wifi does not see that there are endstops. when I do an M119 it says X and Y are not stopped even if I press them manually. I thought I might have plugged them in backwards so I switched the plugs but it did not make a difference. Does anyone know what could be the issue.