"!^xstop" is actually by configuring via config tool is "(active-low, pull-up)" options.
Latest posts made by VladimirK
-
RE: Solved: Homing issue with X & Y after upgrading to RRF3
-
RE: How to set delay for Duet Wifi and 240V silicone heat bed?
@DocTrucker Was watching gcode produced by Cura before custom "Start G-code", there are
M140 S110
M105
M190 S110
M104 S240
M105
M109 S240
M82 ;absolute extrusion modeThe problem is filament will burn at 240 in hotend (become brown) if I'll put G4 S300 (5 minutes) here. Can I change somewhere in Cura to make
M140 S110
M105
M190 S110
G4 S300
M104 S240
? -
RE: How to set delay for Duet Wifi and 240V silicone heat bed?
@DocTrucker For now I'm turning on bed heater in web interface, waiting and uploading job when surface temperature near required (about 5 minutes for ABS 100C).
-
How to set delay for Duet Wifi and 240V silicone heat bed?
After upgrading bed heater from 12V to silicone 240V (from "Keenovo") I have a problem: before it took about 15 minutes to heat to 100+ degrees, now it is several seconds before bed thermistor reports 100C (optical thermometer shows about 20-30 less at that moment) and about 5+ minutes before I can see at least 98C with optical thermometer. E3D Volcano also heats up in no time to delay.
Is there way to set something in Duet Wifi settings to add several minutes before actually printing?