M591: Remote ports not yet supported by this command
-
Hello,
I build config for new corexy printer with Mainboard 6HC + Expansion 3HC + SBC on DSF 1.2.5 & RRF3.01RC5 & DWC 2.07.
I use this command for 2pcs filament sensor connected on 3HC board input io0.in & io1.in
"M591 D0 P3 C"1.io0.in" S1 R70:130 L24.8 E3.0"
"M591 D1 P3 C"1.io1.in" S1 R70:130 L24.8 E3.0"
What is correct result, for this problem, please?Thanks for reply
Lada -
I'm sorry, filament monitors connected to Duet 3 expansion or tool boards are not supported yet. See https://duet3d.dozuki.com/Wiki/Duet_3_firmware_configuration_limitations for a list of current limitations.
-
Thanks much for reply, I wait for version RRF 3.02
Its super HW for control 3D printers.Lada
