Filament-change.g

dc42

So you have pause.g calling filament-change.g, and filament-change.g calls purge.g, but instead of running purge.g at that point the print resumes. Is that what you are saying?

Krohm Koala

@dc42 exactly, do you want me to give you all the gcodes and meta of these ?

dc42

Yes please. Also, please confirm you are running firmware 3.01-RC6.

Krohm Koala

@dc42 Sure I'm running the 3.01-RC6. So there are the files
pause.g
filament-change.g
Purge.g

Krohm Koala

@dc42 Hi, have you got a bit of a time to look at it ?

dc42

Yes. Please try 3.01-RC7. I made a change in that version which I think will fix it.

Krohm Koala

@dc42 So i tested it again on 3.01RC7, exactly the same result, it'll be easy to get around with the new M291 in 3.02 as i will be able to integrate the purge macro in the filament-change.g

Krohm Koala

3.01-RC8 still react the same

dc42

Thanks, added to my list of things to investigate.

Krohm Koala

@dc42 Thanks, i'll overcome this when 3.02 will be here, if you need me to test it another time later, don't hesitate

dc42

@Krohm-Koala, please can you try release 3.01-RC10 and see if the problem is still present.

Krohm Koala

@dc42 i just tested it, so, it's still here, still resume and launch the macro at the same time, blocking everything.

dc42

I'm sorry, I can't reproduce this, using 3.01-RC10 on Duet 3. I had to edit your files a little to make them work on my machine, but they seem to be working. It does runs the purge macro, which asks me if I want to purge. If I say yes, it purges, then asks me again; and so on until I response with Cancel. Then it thanks me for changing the filament.

However, I did notice that the messages that don't have an "OK" button are displayed only on DWC, not on PanelDue as well.

Krohm Koala

I'm using a duet 2 wifi, maybe that's the reason ^^ if you want, maybe I can film what happened to let you see and maybe upload my whole config files, maybe something is wrong ^^

dc42

Are you absolutely certain you are running 3.01-RC10? Send M115 to check.

Duet 2 and 3 firmware are built from the same source code, so it's unlikely that this sort of fault would affect one and not the other.

Krohm Koala

Yes absolutely sure, that's what appear in dwc and with the M115 I'll upload my whole sys/ folder and film what happens so you can see exactly what it does

Krohm Koala

Here is the video : https://vimeo.com/412688450

the config is here : https://mega.nz/file/eQpC2ayT#4tPTbsP3_YXheCTRxhzMyoEwRT6AAZKng-Vt3GKG3ck

i hope it can help

Krohm Koala

@dc42 Hi, i've tested some thing such as, different directory for the purge macro, even put it in sys folder, always the same thing... I also put it out of the filament-change.g, so in my pause.g, i run the purge.g after the filament-change.g, it does exactly the same thing... I also try without the purge, i goes really good ._. don't know why it does that ... maybe i'll try something else later if i got some idea. Maybe i should delete the config.json and config.g.bak but should do anything.

Thanks for your time