How do I get these messages away every 5sec
-
how bout the messages themselves. What slicer are you using? Can you share the gcode file?
-
I used S3DInduktiv_Z_Abstand2.gcode
-
Perhaps this is a new feature in 3.1.0. I haven't tested it myself yet.
I can't read german so I'm not sure if there's an option there.
-
Most likely your slicer has inserted M117 commands in the GCode file that it generated. This is an option in some slicers.
-
@dc42 Not in the case of the gcode he uploaded.
-
@dc42
no it is not an M117 in the entire Gode -
-
@Elko Do you have a daemon.g in your system directory? The only reason those messages can pop up is from a M117 code somewhere in your config.
-
No, it is not an M117 M118 in the entire Gode or in a system / file
-
-
Are you running a Duet 3 with attached single board computer? If that's the case, are you using a DSF plugin that could be generating the messages?
-
Do you have anything connected to the USB port of the Duet?
-
-
I now know where the "error" comes from
I connected Repetier to the Duet2 via WLAN
This will probably poll the data for 5 seconds when I start printing from there
Only for INFO I am fully satisfied with the DUET2 super thing -
@Elko said in How do I get these messages away every 5sec:
I now know where the "error" comes from
I connected Repetier to the Duet2 via WLAN
This will probably poll the data for 5 seconds when I start printing from there
Only for INFO I am fully satisfied with the DUET2 super thingLooks like Repetier is sending those M117 command then! There may be an option in Repetier configuration not to generate them.
-
Thank you for your help
is not your problem !!
such a good support THANKS