Spindle immediately turns off on error

[wackyfrog]

The main reason - safe machining, and catch all inconsistent operations. I have power outage sensor, connected to spindle and the trigger for it:

if job.file.fileName=null
	echo "KRESS tool has been UNPOWERED."
	T-1
else
	echo "Power lost. Emergency stop."
	M112

When I turn off spindle manually – it is just reports that tool is unpowered. But in case of movement error, the trigger raises after job was canceled and can't catch this for safely up Z axis or for immediately stop all machine (like M112).

Look at the screenshoot: first, the execution of the hob canceled, then the power failure trigger was triggered, and only then an error message appeared.

IMO, in the event of a positioning error, stop everything immediately, but do not execute the remaining commands in the buffer.

[dc42]

Stopping all commands in the buffer could lead to a positioning error. Alternatively, I can have the spindle kept on until the buffer is empty. Would that be acceptable?

[A Former User]

@adegtiar said in Spindle immediately turns off on error:

The main reason - safe machining, and catch all inconsistent operations

Yes, so try to catch it in CAM simulation instead of on the Duet? I.e. avoiding it all together.

[dc42]

Or run it on the Duet in simulation mode?

[wackyfrog]

@dc42 said in Spindle immediately turns off on error:

Stopping all commands in the buffer could lead to a positioning error. Alternatively, I can have the spindle kept on until the buffer is empty. Would that be acceptable?

Yes, this will solve the problem of a broken cutter due to movement with the spindle off.

But, Is it possible to catch the error event to run a script to handle the situation? Is it possible to determine that the last job failed? I would like to determine (inside trigger handler) whether it was done manually (canceled) or as a result of an error ? The trigger fires when machine state is idle.

[dc42]

@adegtiar said in Spindle immediately turns off on error:

But, Is it possible to catch the error event to run a script to handle the situation? Is it possible to determine that the last job failed? I would like to determine (inside trigger handler) whether it was done manually (canceled) or as a result of an error ? The trigger fires when machine state is idle.

I guess I could add a "last job finish status" value to the object model.

[wackyfrog]

@bearer Cam simulations is OK. Out of bounds of coordinates occurred due to the incorrect WCS (a few mm was insufficient).

[wackyfrog]

@dc42 Good idea! But in order to correctly interpret when it happened (just) or a long time ago, it would be good to either reset this status on request (for example, after processing inside a trigger) or so that the last status has the time of the event, how long ago it happened at the time of its reading. Just for example:

if {job.lastPrintStatus='some failure code'} && {job.lastPrintStatusAge < 10} ; react if it is a 'fresh' event, not older 10 seconds (or a couple seconds  would be enough for process)
     echo "Last recent job failed";

; proposition for event age value
; if this code executes just after error event
echo {job.lastPrintStatusAge} ; will be 0 sec
G4 S1.0
echo {job.lastPrintStatusAge} ; will be 1 sec
G4 S10.0
echo {job.lastPrintStatusAge} ; will be 11 sec

[rzi]

Maybe a parameter to the M453 command to set if it should be affected by an error or not.

[wackyfrog]

@dc42 Hi, David! Any progress ?

[dc42]

Not yet, but it's on the list for possible inclusion in the 3.2 release.