No movement when position command sent without G0/G1

[PARRS]

Currently running dsf 3.2.2

Is anyone else having issues with no movements taking place when a G0/G1 command is left out? (G1 command was used in the previous line)

I remember this working with past versions but can't seem to get it working. For example a code would be:

G1 X250
X300

The carriage would move to X250, but then no movement taking place after. I get a "check mark" X300 in the console but there's no physical movement or position update in the controller...

[dc42]

RepRapFirmware supports commands in that format, but only when switched into CNC mode using M453. I'm not certain whether DSF on the SBC does, I will find out.

[PARRS]

@dc42
Thanks! I am currently in CNC mode. Tried with a tool selected and no tools selected which results in the same "check mark X###" making it seem like it works.

[PARRS]

@dc42 Any news on this?

[dc42]

@chrishamm is looking at it.