CAMWorks PostProcessor

[Sejl]

Hi,
Any idea where can I find PostProcessor for Duet firmware 3+ for SolidWorks (CAMWorks)?
I have tried using grbl postprocessor, but it has no G, M, T in front of every line, so it's pretty much unusable.

Thanks in advance for any suggestion!

Best regards

[Sejl]

@sejl
Is there maybe some tool that can convert PostProcessor from Fusion360 to CamWorks? This could also be helpful.

Thank you

[mkrsjak]

@sejl hello, did you find a solution for solidworks postprocess?

[3DOeste]

@Sejl you don’t need a special post processor, just use a fanuc one and remove the canned cycles. All the Gs and Ms in every line are no longer needed, it behaves as a normal industrial Cnc, once a command is sent, all the lines following are under that command, unless you change it again.