Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Configure gcode for filament sensor

Solved

Gcode meta commands

1

2

111

Log in to reply

undefined

Auré
last edited by

Hi,

I have connected the filament sensor on the toolboard I think the command is:

M591 P1 C"121.io1.in" S1 D121.0

I don't know where to input this command in config.g

Thanks, Auré
Reprap core XY, Ender 3 upgraded.
The more it fails, the more likely it is to work. The Shadoks
1 Reply Last reply
Reply Quote 0
undefined Auré deleted this topic
undefined Auré restored this topic
undefined

Auré
last edited by

Insert somewhere below where your extruders are defined and change D121.0 by D0
Reprap core XY, Ender 3 upgraded.
The more it fails, the more likely it is to work. The Shadoks
1 Reply Last reply
Reply Quote 0
undefined Phaedrux marked this topic as a question
undefined Phaedrux has marked this topic as solved

1 / 1