Delta (partially) ignores axis limits

tom300z

I just installed RRF 3.5.0-beta.3 an suddenly my machine ignores axis limits. The configuration seems ok as far as i can tell:

M564
Movement outside the bed is not permitted, movement before homing is not permitted

M208
Axis limits (mm)s X-95.0:95.0, Y-95.0:95.0, Z0.0:219.8

However when i move the printhead using G1 or the DWC Dashboard the Printhead just keeps going.

Your anti Spam bot is a bit trigger-happy so the full post is on pastebin: https://pastebin.com/tUgPxD8S

dc42

@tom300z in delta mode only the negative Z limit from the M208 command is used. The XY limits are defined by the bed radius, which is the B parameter of the M665 command. What value do you have that parameter set to?

droftarts

@tom300z said in Delta (partially) ignores axis limits:

Your anti Spam bot is a bit trigger-happy

I’ve upvoted your post, which should help. Make sure you confirm your email address, if you haven’t already, otherwise you won’t be able to reply to this post.

Ian