Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Duet 3 6HC - filament sensor notification but continues printing

    Scheduled Pinned Locked Moved
    Filament Monitor
    2
    2
    133
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Johnnie_Wundefined
      Johnnie_W
      last edited by

      I have a Duet 3 6HC and the filament sensor pops a notification when there is no filament but the print continues. Before I upgraded the printer would pause the print and not allow to resume until filament was detected. I have a simple switch that detects if filament is present. Is there some gcode command I am supposed to add to the config?

      ;Filament detection
      M591 D0 P1 C"io6.in" S1 ; filament monitor connected to io6.in and GND. The Extruder is E0 mapped to Driver:0.4
      M591 D0 ; display filament sensor parameters for extruder drive 0

      fcwiltundefined 1 Reply Last reply Reply Quote 0
      • fcwiltundefined
        fcwilt @Johnnie_W
        last edited by

        @Johnnie_W

        What version of the firmware are you using.

        With version 3.4.x a filament sensor triggers an event which needs to be handled:

        RRF Events

        Perhaps something is missing from your configuration.

        Frederick

        Printers: a small Utilmaker style, a small CoreXY and a E3D MS/TC setup. Various hotends. Using Duet 3 hardware running 3.4.6

        1 Reply Last reply Reply Quote 0
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA