New DuetEthernet connection problems
-
Just wanted to report back saying that I got everything running again in DWC 1.20 and DE firmware 1.21 RC2. I wiped the sys folder after backing it up and recreated my config.g file from scratch using the online tool. I must've done something strange in my configuration that caused it to no longer connect.
-
Not all network cables are equal…
While I had the issues with the DuetEthernet I tried using several cables from the same batch. All of them successfully used with Gigabit capable devices (PCs, laptops etc.) and showing full transfer speeds. Today I had to connect, after a very long period of time, a 10/100Mbps only device and, to my surprise, I had the same issues that I have observed with the Duet. So I have looked through the pile of junk that I have around and found several more devices with only 10/100Mbps networking and found the same problem.
Luckily I also found around a cable from a different batch and now all the networking problems are gone.
-
I'm glad you both solved the problems. I've never heard of cables working ai 1Gb/sec but not at 100Mb/sec before!
-
Do you want a couple of "samples"?
The Windows/Linux devices that I used for further tests always properly negotiated the IP address with the DHCP server but they could not get even one reply from the DNS. So things are way weirder than I could even imagine. Most probably they will end up being recycled so I don't waste precious time when testing/using other devices not capable of Gigabit.
-
if you are in the UK then a sample would be good; otherwise the postage cost will get silly.
-
Sorry for the delay, but I had two rather long days!
Unfortunately I'm just few thousands km to the East of UK so shipping is way more than what's worth paying for a set of poor network cables. But I'm mainly a radio guy (professionally doing things like software radio and related to that) so I have a little bit of equipment here. So I decided to get the big guns into the battle.
A quick frequency characteristic of the cables, good vs poor ones, showed rather poor behaviour at low frequencies for the unusable ones. As Gigabit PHYs are a lot more advanced than 10/100Mbps ones, I presume they were able to overcome the problem, just!
But poor frequency characteristic in the lower frequency range usually indicates a fault in the copper wires. After a few bending cycles here and there and the cracks in the copper turned into actual breaks and the cables are now, a few of them, unusable no matter the network type. Most probably it was a problem with the batch of cable from the manufacturer, but trying to deeply understand a 50EUR problem, spending several days, is beyond any commercial reasoning so the whole batch will go for recycling!
All I can say for sure is the outer jacket of the cable showed no signs of mechanical abuse, either by pinching or pulling, so it might have been a batch of cable that was "good enough" during the factory tests, but useless after bending it a couple of times.
P.S. It was the only time I have bought ready-made network cables!
-
Thanks for the update. I use flat cat6 network cables purchased inexpensively on ebay. No problems with them so far and they are very flexible.
-
I presume UTP and not FTP or STP!
-
Yes, UTP in particular these http://www.ebay.co.uk/cln/kenable_ltd/FLAT-CAT6-Gigabit-Network-Cables/89021312013.
-
As I do a lot of radio monitoring stuff (hardware, software) even my keyboard and mouse are wired. And UTP cables tend to be quite noisy so everything in here is FTP or STP. Unfortunately that comes with a lot more rigidity if keeping the costs within reasonable limits!
