Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    PT 100 reads 2000C

    Scheduled Pinned Locked Moved Solved
    Firmware installation
    1
    2
    289
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • 3DPNBundefined
      3DPNB
      last edited by

      Hi All

      I've recently purchased the Duet WiFi with the 2 pin PT 100 sensor and daughter-board.

      After configuring my software through the reprap configurator. I've been able to home the axis and test the heated bed. However the pt100 just reads a constant 2000C.

      I've found this post which seams to be the same issue.
      https://forum.duet3d.com/topic/1292/pt-100-temperature-constantly-at-2000-degrees-after-failure/19

      Following what was posted there I can see that my PT 100 does indeed have a 100+ ohm resistance when disconnected or connected.

      M305 P1 X0 followed by M305 P1 X200, works fine so it can communicate with the chip on the daughter board,

      Same when run for 201, I've also verified the error reporting is working by trying a channel I don't have such as 202 or 203. and sure enough I get the error.

      Any idea's on next steps?

      1 Reply Last reply Reply Quote 0
      • 3DPNBundefined
        3DPNB
        last edited by

        I've managed to resolve the issue, Incase anyone else comes across this thread in future.

        When selecting "Sensor Channel" in the reprap firmware, I mistakenly put PT100 on E0 input, Changing to MAX31856 on CS1 resolved my issue.

        1 Reply Last reply Reply Quote 0
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA