PanelDue-v2-7.0.bin... Doesn't Seem To Have A "NoLogo" Version?

[CuboidWales]

Hi, I have a 7i PanelDue V2.0, and upgrading the firmware for the first time.

I've read the instructions thoroughly here, and love the idea of putting my own logo on the boot up.

After reading through, I understand that I should be using "PanelDue-v2-7.0.bin", but cannot see a "PanelDue-v2-7.0-nologo.bin" equolivelant.

Is there a way I can still put my own logo on there?

Thanks.

[dc42]

The -v2 files are without logo. The reason is that PanelDue V2 originally used the ATSAM3S2B processor, which doesn't have enough flash memory for a typical logo on the 5" and 7" screens (although there may be enough room for a logo if you use a 4.3" screen). If your PanelDue controller has the ATSAM3S4B chip then you can add a logo.

[CuboidWales]

@dc42 said in PanelDue-v2-7.0.bin... Doesn't Seem To Have A "NoLogo" Version?:

If your PanelDue controller has the ATSAM3S4B chip then you can add a logo.

Awsome, thanks for the fast reply.
I see that my chip reads "ATSAM3S4B", and the spec says its 256 Kbytes, so I'm cuffed about that

Thanks again DC