Sound plays on web-interface when temp is reached
-
I would be nice to have a BING to let you know when the heatbed is heated up or when the hotend is ready.. It takes about 15-20minutes for my heater to get up to snuff and I get distracted browsing for
pornresearch material, but if there was some sorta chime to let me know the printer is ready to go that would be neat
-
Have you try using M300 after M190?
http://reprap.org/wiki/G-code#M300:_Play_beep_sound -
i don't have a peizzo attached to my printer, but i was talking about the duet web interface…
-
From the wiki
If an LCD device is attached to RepRapFirmware, a sound is played via the add-on touch screen control panel. Else the web interface will play a beep sound.
-
Oh.
So, how would I add that to the set temperature interface in the duet webpage?
-
I suggest you set up a macro that sets the bed temperature using M140, waits for it to stabilise using M116, then uses M300 and G4 commands to play a tune.
