M669 command ?
-
Good morning all,
I would like a little clarification ...
I have a CoreXY and I just made an update in 2.04RC3
Now, if I'm setting up my printer: https://duet3d.dozuki.com/Wiki/ConfiguringRepRapFirmwareCoreXYPrinter
I should place my M669 command in K1 mode instead of S1. But change their mode, S1 or K1, I see no difference, is this normal?
Thank you !
-
M667 S1 ; switch to CoreXY mode
M669 K1 ; switch to CoreXY modeS1 is M667 not M669
-
Yes indeed, there is an error on my part. It must be understood:
M667 S1 and M669 K1.But that does not change my question ...
Either M667 S1 or M669 K1, it does not change anything, no difference in operation.
-
@Rudy2A said in M669 command ?:
Either M667 S1 or M669 K1, it does not change anything, no difference in operation.
M667 was replaced by M669 since V2.03. M667 is there for backwards comparability. it gets translated internally to the corresponding M669 command.
