Question about tool status in DWC 2.0.4
fcwilt last edited by
If I do:
G10 P0 S190 R100
everything works as expected, including the execution of the config.g file for the current filament.
In DWC Tool 0 is shown as active and warming up.
If I then do:
In DWC Tool 0 is shown as standby and there is an error message from trying M703 that no tool is selected.
and again everything works as expected.
However it is not very clear in the DWC that no tool is selected. It is showing Tool 0, in standby, as opposed to some sort of "no tool selected" display.
Just a thought.