Magnetic Filament Sensor works!



  • This is not a problem, but more of a kudo's!
    I had just recently purchased the Magnetic Filament sensor for one of my extruders and was working on calibration. I had a fairly long (12 hour) print going. During the print, the sensor kept telling me the extrusion amount was low. At first, I thought it was something I was doing. I kept checking the sensor and the machine. Finally, I ran a print where it wasn't extruding anything. It appears my extruder motor was going out slowly. Every time I looked it was working, but when I walked away it stopped.

    I replaced the motor and everything was running smoothly again! So glad I purchased this, will be getting more in the future!


  • Moderator

    @Gamefanatic3D Thanks for your feedback!

    Ian


Log in to reply