Duet3+SBC: Add Rpi CPU as sensor?
-
@bearer said in Duet3+SBC: Add Rpi CPU as sensor?:
edit2 sort of woks, but there are arbitrary spikes to 0 and 2000 when the sensor is destroyed and re-created(?), even if only using M308 S2 Bn
@dc42 is this intended behavior or could it be avoided when modifying a sensor? (Duet 2 Wifi + RRF 3.1.1)
-
@bearer hah I didn't remember that comment; it's been a long-awaited feature for me as you can see haha
I can barely understand what you're trying to do here, but could there be way to use daemon.g in that case?
-
@fractalengineer said in Duet3+SBC: Add Rpi CPU as sensor?:
I can barely understand what you're trying to do here
After thinking I could change the name instead of the temperature, i figured that I could actually change the temperature for a fixed value resistor by changing the calibration parameters. I.e. 10k ohm could be made to represent any temperature we want by changing the B paramter (or possibly H or L)
you'd have a script running on the pi, parsing /proc/ or /sys/ or wherever the temp read is, calculate the appropriate parameter and send the new
M308code to the Duet viaecho M308 Sn Bn/Hn/Ln | sudo /opt/dsf/bin/CodeConsole.the end result would be that you can graph the Pi temp as if it had an actual thermistor (but admittedly you could also stick the thermistor in the Pi at stage, the other guy didn't have any IO left so didn't think of it)
-
@bearer yeah my IO are also full I'm saving my 4 last ones for a RGBW led strip haha
-
leds only need outputs, if there is an input on the same header it could probably be used?
-
@bearer holy shit I didn't know that
-
@fractalengineer so you mean I can use IO ports in and out for separate stuff?
Like a thermistor on io7.in and a fan on io7.out??
-
@fractalengineer said in Duet3+SBC: Add Rpi CPU as sensor?:
so you mean I can use IO ports in and out for separate stuff?
well, i'd definitively try it - no reason it shouldn't be possible afaik. (but not all inputs are created equal ref https://duet3d.dozuki.com/Wiki/Duet_3_Mainboard_6HC_Hardware_Overview#Section_IO so no thermistor on io7.in in any case)
-
@bearer Ohhh I see it
Ok so every IO port may not be capable of sending pwm / receiving analog , BUT they can all sense a 3.3 or 5V in (for switch, button, endstops etc...), and/or send a 3.3 or 5V out (for servos(?) led?) am I right?
-
@fractalengineer correct, they're all plain old digital I/O and some are fancy.
-
@bearer well damn I just doubled my IO ports in my head
-
Do note I've not tried if say IO1.out can be used as a digital input but they would have none of the input protection IO1.in has in hardware - and it would be down to the firmware to allow IO1.out to be configured as an input.
And using IO1.in as an output would probably also be less than ideal; it would only be possible to get it down to about 1v not 0v.
But hopefully you meant you could use IO1.out independent of IO1.in which i hope to be true.
