Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    configuration change

    Scheduled Pinned Locked Moved
    Firmware installation
    2
    5
    234
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • printingmarkundefined
      printingmark
      last edited by

      Hallo everybody
      i had to remove my bltouch (defect)
      changed the configuration and now the printer homes and try to print about 10 cm above the bed
      can sombody please tel me what i am doing wrong
      config.g
      endstop works

      1 Reply Last reply Reply Quote 0
      • littlehobbyshopundefined
        littlehobbyshop
        last edited by

        Config looks ok to me. Can you share your homeall.g, homez.g, and one of the gcode files that prints in mid air.
        Does the same thing happen if you home each axis independently rather than all together?

        BLV MGN Cube w/Hemera, K8200, Sunlu S8

        1 Reply Last reply Reply Quote 0
        • printingmarkundefined
          printingmark
          last edited by

          homeall.g homez.g

          if I move the axis they go in the right direction
          when i do home all the z axis goes up instead of to the end stop i have seen

          sorry for my
          English

          1 Reply Last reply Reply Quote 0
          • littlehobbyshopundefined
            littlehobbyshop
            last edited by

            Ah OK. Have a look at M574

            Currently you have no Z endstop set in your config.g with M574 Z0 S0.

            I suspect you would instead need M574 Z1, you will need to set the S parameter depending on your endstop type.

            BLV MGN Cube w/Hemera, K8200, Sunlu S8

            printingmarkundefined 1 Reply Last reply Reply Quote 1
            • printingmarkundefined
              printingmark @littlehobbyshop
              last edited by

              @littlehobbyshop that did the trick thank you very much

              1 Reply Last reply Reply Quote 0
              • First post
                Last post
              Unless otherwise noted, all forum content is licensed under CC-BY-SA